Hi, I have several damage Room 70's within our environment, and I wanted to reuse the Codec Pro within the Room 70's as a standalone Codec Pro. The Cisco Room 70 Codec Pro is a regular Codec Pro unlike the MX800 codecs. The issue I'm having is the na...
Forum Posts
Current Setup:I have an AMX Part number: FG1010-500FX (we will call this "RX") and a AMX Part number: FG1010-310 (we will call this "TX").The TX is connected to a Sony PTZ camera, part number: SRG300H, (we will call this "Sony Cam") via a HDMI Connec...
Hello Folks, We have connected 6 PTZ4K Cameras to Codec EQ using unmanaged ethernet switch and and HDMI Switch. Codec detected all 6 Cameras as you can see below. xstatus cameras Camera Connected*s Cameras Camera 1 Connected: True*s Cameras Camera 2...
I'm trying to figure out if there is a way with a Cisco Codec Pro via the XAPI to launch the "native" applications - Specifically what I'm trying to do is create a "meeting providers" panel which would then have choices for Google, Microsoft Teams, a...
Hello everyone I just want to confirm if it is possible that I can use cisco room kit plus codec USB A/B port to use as an external speaker instead of its 3.5 mm jack audio port.
Hi everybody, we have now upgraded several videoendpoints via CUCM from Version10.11.5.2 to 10.19.5.6. 99% are fine after the upgrade. But two endpoint "Cisco Webex Romkit 55 Dual" have lost there directly connected Touch device.It seems to try the u...
Touch8 cannot start normally. EX60 screen prompts "Lost connection with control device".I just want to use the EX60 as an external monitor for my computer.Is there a way to clear the error message on the screen?Thanks!
Cisco has advised that when a Cisco MTR device, registered with Microsoft Admin Centre, is also registered to Cisco WebEx Control Hub, it gets the benefit of a true WebEx meeting experience whilst still on MTR mode. This statement has some firewall ...
I am conducting a large AV project using room kit Pro with (1) quad cam and (1) P60. Everything is working great with that setup, I am using the the classroom room type in my configuration where speaker track is working with the quad cam and presente...
Hello,Is it possible to control the Cisco web ex room 55 by using RS232 ? If yes , which one is the control port ? We can't find the RS232 port on the device.Thanks.
What are the correct configuration steps to follow for windows Jabber to work via CUCM 11.5
I'm looking for a way to hide the "Call from Laptop" button. I could not find it in the User Interface settings.
Hi. I would like to ask regarding Cisco Table Microphone (CS-MIC-TABLE-J). I have an existing SX80 and I would like to use the CS-MIC-TABLE-J, however the connection for SX80 codec is Euroblock (the Cisco Table Microphone is 3.5mm). I would like to r...
Hello I am being told by a consultant that this will work and I am looking for conformation that it is supported in the latest Cisco Codec Plus firmware?In the Codec Plus Admin guide (https://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/ce...
Hi, I have a CS-CAM-PTZ4K camera that I would like to use with 3rd party software or hardware for a temporary conference setup. Is this possible? I have read that the camera is compatible with IP VISCA control. Do you have any recommendations for sof...
