TelePresence and Video Infrastructure

Hi,After starting a conference from MCU with 10 or more participants, for example one location starts to talk, other locations can hear clearly, when one of the other location starts, we can not hear anything at the beginning, after few letters it ge...

I was looking for the old test sites of Tandberg. So i browsed to the online support page on the tandberg site. But i was redirected to a Cisco site.On other pages i found the ip addresses of the test systems. But i was not able to dial them.Are they...

Hi,        I have a question about the One Button To Push for the C series endpoints. I am setting up the new network and all the hardware in the latest software. C series endpoints on TC 5.0 and TMS on 13.1.2. According to the release notes, C serie...

If I setup a SIP trunk between a VCS Control x6.1 and a CUCM v7.1.3 cluster with a CUPS-server and  CUPC clients.I've enabled Presence on VCS side and configured the SIP trunk for presence but the presence status is not showed on the CUPC clients and...

Hi,I'm new to VCS Expressway. what would be its intial configuration so that we can make external calls?I've already configure VCS control and it's working great. I'm just new to VCS expressway..please help...

We have a CUBE connecting our CUCM environment to other enterprises via SIP trunks.  Is it possible for this CUBE to accept SIP registrations from remote video endpoints and funnel them back to the internal CUCM?Thanks!Jeff

I have a 2901 router with a EHWIC-D-8ESG-P card in it. I have configured a DHCP Pool for the voice vlan but the phones get an IP address from the data vlan. What am I doing wrong..,?ip dhcp excluded-address 10.2.100.1 10.2.100.30!ip dhcp pool Phonesn...

Hi,I've setup TMS to send out email alert but it didn't send out an alert when I unpluged one of Ex60 device that was registered in TMS. why is that? I do I resolve it?Thanks...

Good day, I was looking for a codec series C that could accept a 2 screens set up, I guess It should be one for the DVI out, and the other one in the S-Video out, I was thinking that it had to work with one screen showing the remote camera view and o...

Hi We have deployed the vcs control and expressway solution. For some users the movi client after login disconnects within 5 minutes and takes a long time to reconnect back. All the users are connecting to movi client from the internet segment. users...

Hi,Can anyone advise where i can download the MIBs files for Cisco TelePresence endpoints and infrastructure products?Thank you.ian

HelloIs it possible to buy a camera bracket for this device?You know, to mount the camera on your TV. It's included to QuickSet, but it isn't in Cisco Integrator Package C-Series.If yes, what is the part number?Thanks.

Hello;We had new Installation of CUCM 8.0 (1 Pub, 1 Sub) and H323 Gateway, Having 9971 Vedio IP Phones. Normal Voice calls incoming and outgoing are working fine,  when I Enable Vedio Capability from 9971 Phone Configuration, Internal Calls from 9971...

Hi ALL,I have this 525g ip phones that obtain ip addresses dynmically but on the screen of the phone there is no display(no infor abt user,number etc)but the other 504G work very wellplease what could be the cause for thisThanks