TelePresence and Video Infrastructure

Can someone help to verify if the TelePresence ISDN Link (CTS-ISDNLINK-K9) supports SNMP?I've been reading the Admin Guide and API Reference Guide manual but there were no SNMP configuration settings.

What's the difference between CS-KITP60-NR-K9 and CS-KITP60-K9

Hi All,I want to setup our meeting servers so that user spaces are created with certain callProfiles, cllLegProfiles and accessMethods. This is to allow for user created spaces to have the correct settings on creation, members are hosts with meeting ...

Hi,   I have Cisco Webex Room 70 Single G2 registered to CUCM version 12.5,I purchased Webex Device On-Premises Subscription license for Cisco Webex Room 70 Single G2 to register to CUCM.Now for video conference, I know that it must exist Video confe...

We have a bunch of the new Spark Room Kits, and on some endpoints we are receiving a PeopleCount of -1. What does this mean?   People counting out of call is enabled, people presence detection is on. 

Hello Team.   While trying to manage remotely a Webex Codec Plus via Web Interface for a remote office, I have noticed that when the system was on "Speaker-Track"  the zoom-In capability of the endpoint was "better" than when the "Speaker-Track" was ...

TECHNICAL REQUIREMENTSWe would be pleased if you could answer the attached table in a detailed way.Cısco Webex Video Conference ProgramCan you also mention about pricing policy? (please specify the prices for 25, 50, 100 participants? Are there separ...

Dears, Your input is much appreciated. I have multiple Dx80 installed in the project, all registered to cucm 11.5 and media resource is the CMS.For the Dx80 i have two options if i set the multipoint conference to :1- Auto: i can conduct meet me and ...

Dear all, is it possible to show the video picture on both screens ? Thanks and regardsPetra

Hi, I am literally stuck. I have configured the SIP details and in the Home page, it shows the following SIP status   IP Proxy 1 Status Registered Proxy 172.31.2.52 URI 8077@172.31.2.52 From CUCM, it also show this device is registered. I can dial ...

I have a client with an MX800 registered to their local CUCM.  They now want to have it registered to Webex.  Is there a document explaining what needs to be done on the MX800 to move the registration from CUCM to Webex? Thank you in advance

Hi Guys My new Cisco Spark Board 70, out of the box, started downloading new software (around 10 minutes) then it got stuck on "installing New software" for almost 3 hours... forced restart and then the whole process repeated again. How long does it ...