TelePresence and Video Infrastructure

I have an SX-20 Telepresence device with two TVs hooked up.  Users typically don't use the camera for Webex meetings.  So when we join the sx-20 to the meeting, it shows the active user speaking (or their cam if it's enabled) on the one screen, and t...

I am having an issue, on TMS15.9 / TMSXE 5.9 if the meeting organiser books say 2 VC room bookings and also adds the scheduling mailbox all works fine, gets the notification back from exchange saying the room bookings confirmed then receives an email...

Hi All, We recently purchased some Cisco WebEX Room Kits and a CMS to integrate into our current CUCM cluster. We haven't installed the CMS as of yet, i've just registered the Room Kits to verify functionality and services. We attempted to dial into ...

We have a dying C60, replacing with a SX 80 with a Crestron controller. We just use the Crestron to route signals, no camera controls, we still use the C60 remote to send content after the Crestron routes everything. The install company is trying to ...

What's the best solution for Cisco SX10 Quick Set's "audio input" (4-pin mini-jack) when there is more than 10 users during one "video session" in the room and there is need to have good sound transmitted together with video?I just found that suggest...

Expressway (MRA) v X12.5.7 Based on a request from our security department, we need to disable TLS v1.0 for MRA on our Expressways. We were able to disable TLS v1.0 globally -- but it still looks like that applies only to SIP but not to MRA. We can s...

We are going to migrate from a deployment with meeting server edge to webrtc proxy on VCS expressway.Acording with configuration guide of CMS, external and internal ip address of expressway must be configured creating the turn server on CMS. In our d...

New implementing video conferencing on existing CUCM 11.5 what are the required BoM I have 4 sites that will do video conference HQ will be connected to 4 branches over VPN.HQ - C3900-SPE150/K9Branch 1- CISCO2911/K9 Branch 2- CISCO2951/K9 Branch 3- C...

Hello, my company has a complete on premise videoconference infrastructure : CUCM, Expressway-C and -E, TMS, CMS, Room kit and SX endpoints...I would like to display audio messages in the videoconference meetings that are booked in our TMS, like "the...

Hi all, I'm having an issue with guest access to WebRTC. After entering the Call ID, it attempts to connect to the space (even prompts for access to their webcam and microphone) but then never connects and cycles back to the Enter Call ID page. Inter...

Running SX80 with ce9.8.1Need to turn off the timer on the selfview cam ctrl pip.. xConfiguration Video CamCtrlPip CallSetup Duration: 0 not working ??? Any ideas please.