Hi all,I want to migrate my VCS\VCSE from hardware to virtual. Both servers are covered by active maintenance contract.How does licensing work in this case? What is the transfer procedure?Any cost involved?Thank you.
C-40 is registered with CUCM .While dialing ,SIP URI with Domain name as suffix is working fine .
C-40 when URI "dialing". While SIP URIs uses an IP address as the suffix, Call is not working in this scenario
Please suggest me
example :
URI : 4700...
we need to verify what the VCS has enabled / disable as far as encryption.
The VCS must have- DES encryption disabled.- TLSv1.0 disabled.- CBC encryption mode disabled.- RC4 hashing disabled.
How do I go about confirming this?
Hello, I need to register endpoints over SIP to my VCS Expressway with authentication. I am able to register the SX80's installed at my customer site but somehow when trying to register the customer's SX20's, i get a "received from unauthenticated so...
Hi,
Can anyone let me know is it required to change the bandwidth configuration on the Expressway C and E server.
I have endpoints MX800, DX 80, EX80 and C60, will this impact the quality of conferencing and B2B video calls.
I also have the TMS, is ...
When configuring an NTP server IP address or hostname on a TC endpoint, you can only enter one address. Does anyone know if this supports SRV records, or is there some other way to achieve redundancy for NTP?
Hi,
One of my customer suggested a scenario. They have 5 sx-series telepresence endpoints which are registered on CUCM. Also they have one telepresence content server for recording purpose. All are connected to same switch. They are suggesting to do...
I have a problem with EX90 microphone issue. Internal microphone started not to work, then i tried the handset and the c20 microphone but still no success. I can't send the voice to other side. I tried all the settings at web interface but same.
Als...
I have a question regarding on this Bill of Material. This is already an old BOM and just want to clarify something if there is missing here.
I will deploy a Conductor and Expressway Core as virtual machines (co-resident) on 1 UCS C220 M3S servers. T...
Connecting to the API, according to API Reference Guide tc-7.2 can be done with a USB to RS-232 adapter to connect to the USB port. I would appreciate feedback from anyone who has tested. (Can any of usb ports be used)Thanks ;-)
Hi there,
I am running a number of SX-20 VC units and finding them to have issues with sound with some devices. I am having VC's with basically no sound .. (scratchy inaudible voice from the other end) when connecting to older machines (Aethra X3 and...
Hi,
Our MX800 has crashed from a stadby mode:
The screen is blackNetwork interfece is in shutdown stateThe touchpanel is in unpaired state and can't get a IP address from MX800 DHCP
We tried to reseat all the cables, physically restart the MX800 an...
I am see "No Lan Acitvity" message on the EX90 touch panel but the endpoint is connected to LAN and able to establish video calls.
Endpoint is registered to VCS SIP-H323
Firmware 7.3.3
Recent change in environment is, turned off and uninstalled the...
After rebooting the C40 codec the camera does not communicate or provide an image until all cable connections and power are removed and replaced. This occurs on numerous endpoints and has persisted through software upgrades.
Currently. TC 7.2.1
