TelePresence and Video Infrastructure

C40 shows no lan connection . i have already changed cable and factory reset the device but issue still persist. Pl help me out.

HelloI have the following setup:TMS with TMSPE VCS-C and VCS-C and a SIP Trunk to the CUCM We provision user information from TMSPE to VCS-C and then use delegated credentials check to VCS-E. This works.We have a SIP Trunk from CUCM - VCS-C It works ...

Hello,Does anybody know if the Cisco SX10 need a sip registrar to do any call?Does sip registrar could be an Asterisk?Otherwise, can I do a call between 2 SX 10 only with ip address without any sip registrar?thanks in advance

Need some for an ongoing issue BackgroundI have a customer that can connect to a old MPS800 but cannot connect to Codians at three separate hub sites:Hub A - MCU 4510 4.4(3.67)Hub B - Codian MSE8000 with 6 8510 blades 4.4(3.42)Hub C - MSE 8000 with 2...

Hello,I have my Video endpoints registered to the CUCM and when I get an inbound call to my video endpoints from the external network via VCS-E--->VCS-C--->CUCM, I only get the display name of the external endpoint and not the SIP URI, so I cannot ca...

Please streaming Option available in Cisco Telepresence 5320 MCU.

Hello, I would like to know if the registration process of a video endpoint (e.g. SX20) to UCM is similar to the registration of ip pphones, By that I mean if the video endpoint downloads a TFTP file form CUCM to take its configuration. Thanks,Luis.

Hello, I am trying to get a new E20 registered to CM 10.5.2 and it is getting rejected. I have triple checked all SIP settings, etc....and I dont see anything configuration related that may be causing it....pls help.

Hi,  kinda new at this, how do I get the logs on the end point of a dropped TP conference

Everytime we perform a factory reset or turn unit off/on a good portion of the settings are not transfered to the CODEC. Works great with TC5.1.13. We are running TMS 14.2.2 along with TMSPE 1.0