TelePresence and Video Infrastructure

Hi, I just upgraded my VCS C and E from x7.2.2 to x8.1.1. Everything appears to be working except I get no media when calling from the internet to a single video endpoint or into a conference on the TP Server. I've tried from Jabber as well as an EX9...

I installed Cisco TMS 14.3.2. But when i open web interface in any browser, it is not open. and page not display

What is the latest stance on TMS/TMS XE supporting the Microsoft 365 environment?

we have a scenario where  5 "9951" Cisco video phones and 5 "SX20" units Plus other voice phones all in one site (Location) and we want to be able to create video conference between the video endpoints (3+ units video call ).and possibly with any oth...

Hi,Our customer has a BE6000 solution, they want to acquire two endpoints SX20 for a telepresence solution. Does they need any special requirement or license to add the SX20 into the BE6000 solution? Want would the customer need to integrate the SX20...

we have VCS server with MCU 5301.There used to be 12 participants earlier in one conference but now only 10 participants can be in a conference I mean I can not call 11th participant. If I need to accommodate the new one, one of the participant need ...

When building a traversal zone between VCScc and VCSew does it matter if VCScc has sw. X4.x and VCSew has sw X8.1.1? Regards, Natalia Vendel

Hi everyone Recently, SX20 has interoperated  with 3rd SIP server & MCUregister & Connection was done , But it has a problem about video qualityThe symptom is that Video packet loss has continued generated from MCU to SX20 (Network status is fine , S...

I'm in a workplace that's blessed with a full mix of endpoints and infrastructure now facing bringing it all together.Can anyone shed some light on if / when Cisco TMS may support Polycom Group Series Codecs & RMX. Does anyone have any work arounds o...

All, I have recently been experiencing problems with our oversea’s telepresence endpoints when performing MCU calls, the customer is complaining of an intermittent blurring on all oversea endpoints are on a bridge calls, all P2P call are good quality...

For telephony, I've always trusted TRUNK uplinks with the "trust cos" command, and access-port uplinks with the auto qos dscp command. This has never been am issue because the switchport DSCP<-> COS mappings would map COS 5 to EF and COS 3 to AF24 or...

All of sudden Cisco EX90 Self View picture looks compressed vertically. What should I do to make the picture look normal?