Hello everyone I have curious to know the cause of reboot of a C40, today a C40 was rebooted suddenly, there were no electricity issue in the building and anyone did the reboot in local or remote.I tried read the LOGs but i didn't find the correct li...
Dear all, When i try to integrate Expressway-C and E with CUCM 8.6.2 as proxy for Mobile Remote Access (Not SIP Trunk), I receive this error "not supported version". I know that Expressway only working with CUCM 9.1.2 and later. But my question is: -...
Hello,i have a lab deployment with vcs-c and vcs-e. I try to configure a secure traversal zone for delegate credential checking.Is it possible to use the default server certificate of the vcs for this issue? How can i configure vcs-c and vcs-e to tru...
hiwhen i open TMS 13.2.2 on my any browser(Google Chrome, Mozila or Internet explorer) after opening when i go to conference control center then their is error display when i click on error detaols then this msg display which is below mentionUser hom...
Hello,I've deployed 2 VCS Expressways in cluster with X8.1.I've enabled debug mode for H.323 and SIP.On both VCS's I see these errors when going in Status-> Logs: Eventlog: Error: Cannot read the Event Log /mnt/harddisk/log/messages.5.Configuration l...
We have a customer that is moving from Exchange to Google Mail. They also have a full WebEx/TelePresence integration with the current Exchange environment using TMSXE. We're concerned about resource scheduling functionality in the future and want to ...
Hi Cisco techs,A simple question that google can't seem to answer after the varied searches I have doneWhat voice interface cards go into an NM-1V device?I had purchased a 1 port ISDN BRI S/T WIC interface, placed into device but not show enabled in...
Hello.From March 31st, 2014 SX20 is equipped with premium resolution without extra cost. But I am unable to order Premium resolution license via Cisco Commerce Workspace for existing SX20 systems. How I can get this license for sx20 obtained before M...
I have a C60 with compositing enabled. When you do a point to point (via Jabber, or Endpoint) it works fine for the far end. When you dial the C60 into a bridge on our 8510 blade it only shows one of the cameras, like the compositing is disabled. ...
Hi all, i have a question regarding QoS on non-trunk links.If i have two switches connected via a normal uplink (no trunk) and a frame is sent from one switch to another no CoS information is included in this frame as it is not a tagged frame, but ho...
HiThis is just to let you know that TC6.3.1 and TC7.1.1 now are available for download on cisco.com.The openSSL version has been updated to 1.0.1g which includes a fix for Heartbleed. Regards,Johan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
