TelePresence and Video Infrastructure

While attempting to add a Cisco E20 to a multi-point Secure Conference in TMS, we receive the following message.Cannot add Sip Participant in a Secure Conference Due to Wrong Encryption SettingsAny idea what is causing this?  Is this not possible?  T...

Hello all!This is my first post here so I hope that this in the correct community topic... I also tried searching but could not find any topics on this.I have a problem when exporting data from our TMS (version 13.2.2), I look under Reporting --> Cal...

I am working with a customer who would like to deploy EX60 across internet connections that are provisioned and monitored remotely.They would like to have the system provisioned with SIP URI, Server, System Password and load certificates so that TLS ...

We have a C90, the only C90 out of 800+ endpoints. We have noticed that when we access a folder within the directory that has more than 50 entries, the C90 only displays the first 50 entries. We have done a restart, a reboot, a factory reset, everyth...

Hi,We are integrating VCS Control and CUCM via SIP trunk for video endpoints registered on the VCSc and IP phones registered on the CUCM to be able to communicate.VCS endpoints dial plan: 49xxCUCM IP phone dial plan: 797xxxxIP address of CUCM peers: ...

Running CallManager 9.1 with VCS 8.1, this call came in from the Internet via VCS Expressway and shows our Sub ip address.Is there a standard on how a SIP Video endpoint should show Calling Party Name and Calling Calling Party Number when using URI d...

Is it possible to call a C20 endpoint to endpoint with a Movi client?

HI All,VCS X7.2.2I am facing some problem with DNS SRV Records. Please see the below mentioned logs which i collected from EX90.--------------------------------------------------------------------------------------------------Jul  2 12:58:27 ppc appl...

I have a problem with my C40 Codec connecting to ISDN, are there any settings on the C40 that enable ISDN to work?Thanks,Mark                  

Hey Folks,Can someone share the List of "Disconnect CauseCode" Numbers and what does each of these refer to for an EX90 unit.Thanks,~K

Hi FolksWe had Codian MSE 8000 chasis which is fitted with the following blades 1) MCU blade 85102) Supervisor blade 80503) ISDN gateway 8321 We want these blades to be upgraded to the latest versions of the software.Please confirm do we require rele...