TelePresence and Video Infrastructure

HelloI need help please , i have a solution for video conference. I have an existing CUCM cluster v9 , and i have a video endpoints (9971 , E20 ,E60). We need to do video conference (ad-hoc conference ) , after my studying i think i can use Cisco MCU...

Hi,A customer needs update your mcu software to new version. Actually, they have installed the version 4.0 ( 1.49 ) and we need the actual software for possible reversing. Someone know where can i download this software MCU 4.0 (1.49) ?? Regards !!!

Hi all,We have a link on our VCS Control  that we want to limit to 1MB for total calls. We tried putting a pipe on the link, but this just means that it will take a couple of calls at 512, and then downspeeds the third one to something ridiculous lik...

        We recently upgraded from 13.1.1 to 13.2.2 and then a week later to 14.3.  We can see our legacy template for Booking Confirm and have cut and pasted it into Booking Invite but are still getting the wrong one sent (bare bones confirmation) wh...

Hi everybody,a short question. While the installation of the jabber video I need adminrights. That's fine.But do I really need adminrights to run the jabber video software after that?We have here problems, that without the adminrights the integrated ...

Hi all,we struggeling a bit in order to config an isdn gateway 3241 behind a pbx from alcatel omni pcx enterprise. Basicly is all working, but the calling party number is not completed. Is there a way to set the byte 3 in isdn to "national" or "priva...

                   I am trying to set up LDAP communication on the VCS Control.  I am currently experiencing an error on the VCS Control with software X7.2.1.  error message reads Invalid VCS Bind Credentials.  All of the credentials and LDAp tree pa...

Hello,Is it possible to add dummy VC endpoints (rooms) in TMS/TMS-XE, like in CTS-Manager.If you schedule one of these dummy rooms in Outlook it will be seen as an Interop callThanksRegardsHarald                  

I have a C40 endpoint that after sw update from 5.1.4 to 6.0.1 suddently has a disabled "Call Control" button in the web interface, and a disabled "Restart" button. I have both proper release key and a valid service contract for the endpoint. Besides...

I've a strange problem.we have a c20 system that is registered to a vcs-c running 7.2 we have a firewall (palo alto) and a vcs-e that sits on the internet. We have one ACL rule from the vcs-c to vcs-e to permit any traffic. This seems a standard set ...

Hi. I have here a nice spare Touch 12 panel that lays around. Has anybody ever tried to bring this to work an other codecs than TX?Danny

Hello all,We have VCSC(X.6), TMS(13), and MCU(4.2) in HQ, and VCSC(X7), TMS(13.2) in Branch office.Currently they work separately, we are planing to configure intercluster trunk, so that the endpoints registered in each sites will be able to call eac...