TelePresence and Video Infrastructure

Hello, I have a client who has several VC systems connected to a CUCM. The CUCM has a SIP trunk so they use them to make calls as well. All of the VC can make multiparticipant calls with the add call button on the touch panel except for one that can ...

All-We have a customer that would like them mounted in a secure mount, with tilting capability. Is anyone doing this, and if so, how? Are you able to remove the kick-stand on the back without too much trouble? Thanks in advance.SJ

Ok using the Cisco Room Kit Mini as a VTC device, yet out of the box the  "WebcamOnlyMode" is turned "On" by default. So when I power up the Touch 10,  I do not get the startup wizard. I get trying "Connect to room device". with the spinning donut at...

How can I self register my Cisco TelePresence SX-10 DeviceCan someone send me the link to register my Cisco Telepresence SX-10 so I can use the device among my other colleagues. I have the serial number and the MAC Address. Please assist.Sincerely,Bi...

Is this command still supported in 9.15: Audio Microphones Mute EnabledDefine the microphone mute behavior on the device.Requires user role: ADMIN, INTEGRATORDefault value: TrueValue space: True/InCallOnlyIt shows in the Configuration pages, but sett...

Hello, I'm wondering if there is any solution to make an automatic back-up config file for the VCS C&E. Please share your knowledge. Regards, Firdaush

Hello,Is it possible to turn off the booking notification on CE9.10 for SX20? I am not seeing option.Does new CE release have that option?

Does any one face the same issue? Not able to pin a specific video of a participant? The Cisco Room Kit does not actually pin the video after I clicked the lock button in the video. 

Hello,We have a setup consisting of a SpeakerTrack 60 and other two external P60 cameras.We need the information about the P60 camera position (pan, tilt, zoom, focus) while the SpeakerTrack is active so that we can calculate and send the position to...

Hello All, Looking all over for an answer.  Have a customer with multiple On Prem registered endpoints.  They state that they don't have the option to add another party to a call on most of the endpoints, but do on at least one. So no Add Call button...

Hi, There is a way to use a screen as default for presentation and for conferences ? ( If there is a presentation it wil be displayed on the screen 2 and if there is no presentation the participant will be displayed by default on the screen 2 )If i c...

When I try to do things in TMS, Its takes a couple minutes for the page to load. It could take 5 minutes just for the page to load. Other times, it loads as it should. Mostly it takes a couple minutes to load a page. It takes at least 5 minutes when ...

We don't use the CS-Touch or Navigator for controlling the codec in the room. Instead we use I third party integrator to control the codec through serial.SO my question is, Can the CS-T10-WM-BR= be used to convert the CS-T10-TS+ to a CS-T10-WM-K9= ?W...