TelePresence and Video Infrastructure

Hi everyone :I created 20 participant templates, in order to let MCU can call these codecs that are not managed by TMS, and then I creat a conference template and put these 20 participant templates in this conference template, but it shows "There are...

Hi,I was wondering what do I need in order to have a multisite conference with a SX20 quick set?I understand that the SX20 has an internal MCU, so there is no need for a MCU.Will I be able to have lets say 3 branch offices in one video conference jus...

Hi Guys,hope you can help me with my incompetence.I Tried quite some time to make following work.On my Sisters Company we have an ISR 2901 (SEC-CME Bundle) with CME 9.0 running. Also we have an ATA-187 with the latest Firmware (9-2-3-1). The CME is c...

Question:in CTMS there is a VIP option and Lecture mode so its pretty easy to configure.On the otehr side, Im using TPS 8710, and what i want to achieve is the following:Start a meeting, join 1 participant, (triple screen) lock it.The other participa...

Hello!Could you please help me with correct B2BUA settings?Now I am trying to migrate from direct SIP trunk to Lync in VCS X6.1 to B2BUA application on VCS 7.3 fully following "Cisco_VCS_Microsoft_Lync_2010_Deployment_Guide_X7-2" and ran into some pr...

Did anyone else see this error, when accessing the (Legacy) Provisioning Directory in TMS 13.2.1.It was upgraded from TMS13.1.2 earlier which worked like a charm. After the upgrade everything looked ok.Error connecting to the local LDAP server The sp...

Hi,I need some help with regex.1) any pattern that starts with 15 and if it is 12 to 15 digit long (including 1st digits 15) than consider it as a good match and then send the call to destination zone2) any pattern that meets requirements in (1) but ...

Hi all and thanks for looking.We have a SX20 deployed with the touchpad connected to the same VLAN, but it's constantly losing connection to the codec.  We have to reboot the touchpanel and repair it to the codec everytime.  Is there a setting/config...