cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

348
Views
0
Helpful
3
Replies
Highlighted

C-Series dual usage of RC and TouchPanel

Hi there,

normally the RC would be set out of function, if I register a TouchPanel to (f.ex.) a C60 codec.

Is there any possibility that allows to use the Remote Controller at the same time?

Maybe with a hidden xconf or xcom command?

(SW Vers. TC5.1.0)

Many thanks in advance!

Fabian

Everyone's tags (4)
3 REPLIES 3
Cisco Employee

C-Series dual usage of RC and TouchPanel

Hi Fabian,

There is no hidden commnad to activate both at same time,

kind regards,

Dharmmesh

C-Series dual usage of RC and TouchPanel

Thank you both - Dharmmesh and Mubashshir

Enthusiast

C-Series dual usage of RC and TouchPanel

Hi Fabian,

I am afraid that would not be possible. By design, the Touch Panel takes the full control of the OSD. If you wish to use the remote controller, the only way is to disconnect the Touch Panel. There is no hidden command to disable this behavior.

Regards,

Mubashshir Akhtar

Thanks Mubashshir Akhtar
CreatePlease to create content
Content for Community-Ad
FusionCharts will render here