I give a mxp 95 at a far location over a satellite link at 512 k. When I try to establish a call to it from the mcu the max rate the call will establish at is 192k. There is no max bandwidth set on the codec or mcu. Any ideas
Hard to tell. You can run xcon and xstat to see the config and status of the system. Then run: syslog on, place the call so we can see whats be requested in both directions for BW etc. Should to see. 192 for video? What audio codec is in use?
Does the call estabish at a different rate if your dial it in the opposite direction (endpoint to MCU)? Could help to pinpoint where the cause of the issue is, on the endpoint, or on the MCU, or something else?
Please remember to rate responses and to mark your question as answered if appropriate.
Wayne -- Please remember to rate responses and to mark your question as answered if appropriate.
AI is going to change many tasks and, as a result, many jobs.
In this podcast on artificialintelligence in the workplace, we explore how jobs may change--and what companies can do to keep workers ahead of the shift:
Check out the podcast:...
Join this featured IT Admin Control Hub session where you’ll hear about the improved Meeting diagnostics capability in Control Hub which provides IT Admins richer insights about their meetings, the participants and the quality of service. See metrics to h...
This document explains how to register a Cisco TelePresence or WebEx device to Cisco WebEx Cloud Service Using API or Local Web Interface use. This procedure is applicable for Collaboration Endpoint Software 9.8 and later. In previous versi...