12-27-2013 07:19 AM - edited 03-18-2019 02:21 AM
I give a mxp 95 at a far location over a satellite link at 512 k. When I try to establish a call to it from the mcu the max rate the call will establish at is 192k. There is no max bandwidth set on the codec or mcu. Any ideas
12-27-2013 01:07 PM
Hard to tell. You can run xcon and xstat to see the config and status of the system. Then run: syslog on, place the call so we can see whats be requested in both directions for BW etc. Should to see. 192 for video? What audio codec is in use?
VR
Patrick
Sent from Cisco Technical Support Android App
12-29-2013 03:10 PM
Hi Paul,
Does the call estabish at a different rate if your dial it in the opposite direction (endpoint to MCU)? Could help to pinpoint where the cause of the issue is, on the endpoint, or on the MCU, or something else?
Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
Please remember to mark helpful responses and to set your question as answered if appropriate.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: