I give a mxp 95 at a far location over a satellite link at 512 k. When I try to establish a call to it from the mcu the max rate the call will establish at is 192k. There is no max bandwidth set on the codec or mcu. Any ideas
Hard to tell. You can run xcon and xstat to see the config and status of the system. Then run: syslog on, place the call so we can see whats be requested in both directions for BW etc. Should to see. 192 for video? What audio codec is in use?
Does the call estabish at a different rate if your dial it in the opposite direction (endpoint to MCU)? Could help to pinpoint where the cause of the issue is, on the endpoint, or on the MCU, or something else?
Please remember to rate responses and to mark your question as answered if appropriate.
Wayne -- Please remember to rate responses and to mark your question as answered if appropriate.
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...