cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
820
Views
0
Helpful
1
Replies

Call to Premium rate number fails after 3 rings

michael.lacey
Level 1
Level 1

Have a cucm 7 installation with H323 gateway to PSTN

Trying to call a premium rate number and the call fails / disconnects after 3 rings.

Have ran debug isdn q931 and debug voice ccapi and they indicate call is being passed to PSTN via correct dial-peer etc... but they only indicate "normal call clearing" when call is diconnected...

DNA shows hitting right route plan too

If you call number from a mobile it rings once and connects to IVR...

have passed this onto telco but they advise there is no error on there part.

Does anyone know if this could be a cucm issue, or if there is a way to 100% confirm its not?

Thanks

1 Reply 1

Maxim Denisov
Level 3
Level 3

Check who sent disconnect in debug isdn q931 output. If it is received from the telco ask them why, probably you set incorrect type/plan or ANI. If it is sent from gateway check the sh call hist vo id $id for internal error code and release source. If you find that disconnect sent by UCM check the traces in RTMT.

Regards, Maxim

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: