12-03-2013 06:40 AM - edited 03-18-2019 02:14 AM
Hi,
I would just like to know wheather calls are possible between two C40 telepresence device without being registered to any of the devices (CUCM, VCS or Webex Telepresence) only on IP address (IP V 4) and H323 protocol within the office network (LAN and WAN).
Any help would greatly be appreciated .
Regards,
Ashish Bagla
12-03-2013 06:46 AM
Hi Ashish,
yes, this is possible.
Best regards,
Alex
12-03-2013 07:11 AM
Hi Ashish,
yes this is possible, provided both devices on communicable network and with call setup as direct on C40, along with default protocol as h323
12-03-2013 05:26 PM
Hi Ashish,
Yes, you can (with the default, out of the box settings), dial the IP address of one of the C40s from the other.
There are some other threads in the forum with similar queries and some configuration examples. Try these links:
https://supportforums.cisco.com/message/3964513#3964513
https://supportforums.cisco.com/message/3937633#3937633
https://supportforums.cisco.com/message/4014370#4014370
Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
Please remember to mark helpful responses and to set your question as answered if appropriate.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide