I have a codec SX80 with a camera precision 60, is connected as Installation guide show it. but I cannot control the camera via web. My Config is(See the image attached):
Could you help me told me that I need to control the camera via web?
Can you control the camera from the Touch 10? If not, do you have the Ethernet cable connected between the camera and one of the peripheral Ethernet ports on the SX80? Also, what software version are you running?
I am guessing that your issue isn't that you can't control the camera, but is that you just can't see on the web interface what the camera is pointing at.
If you click on the arrows and zoom buttons on the web interface, the camera will likely move.
You can't see what the camera is pointing at as you possibly don't have a "Remote Monitoring" Option Key installed on to your endpoint.
The "Remote Monitoring" Option Key is an additional licence that you will need to purchase for any endpoint which you wish to be able to see the cameras in the web interface.
You would purchase this through your normal Cisco purchase methods.
There is a section on Remote Monitoring on page 212 of the SX80 Admin Guide.