Solved: Cisco 5300 MCU Unable to register to SIP Registrar

awatson20 · ‎02-26-2013

I have a new Cisco 5300 MCU that I have just begain initially configuring. Under settings, SIP, it says registered. However, under the conference I setup, it says registration failed. If I click failed, under statistics it says SIP Registrar ID, unable to register. Any reason why? Thanks.

awinter2 · ‎02-26-2013

Did you make sure to tick 'Allow numeric ID registration for conferences' on the Settings > SIP page on the MCU?

If yes, did you make sure to actually populate the 'Numeric ID' field with a numeric value for the conference in question when attempting to SIP register the conference?

View solution in original post

awinter2 · ‎02-26-2013

Did you make sure to tick 'Allow numeric ID registration for conferences' on the Settings > SIP page on the MCU?

If yes, did you make sure to actually populate the 'Numeric ID' field with a numeric value for the conference in question when attempting to SIP register the conference?