Cisco BE6k and VCS Core/edge

[Arbenjamin]

Dear all,

There is a new Be6k High density in the testing environment.

However, we don't have clear picture on the deploying VCS Core/edge with the CUCM in the BE6k.

1. Do we install the VCS core and edge in the same BE6k server? After that, the VCS edge assign with a DMZ ip address?Or install other VCS edge from the appliance?
2. How is configuration between CUCM and VCS? Since I can't any related document from the Cisco.com.

Best Regards,

Ben Lai

1.  

[Jaime Valencia · Accepted solution]

1 Either works, you just need to make sure to properly design and configure the underlying network and the ports to which each VM will connect

2 There´s PLENTY of information on that

http://www.cisco.com/c/en/us/support/unified-communications/telepresence-video-communication-server-vcs/tsd-products-support-series-home.html