Cisco CVUC/IPVC 3511 MCU Recovery

[andypoore]

All

I have a 3511 MCU which isn't booting, I get:

Invalid application on flash. Running Wakeup program

I get a prompt, but I cannot find on documentation on the CLI syntax or if its possible to recover and restore the box.

If anyone can help it would be greatly appreciated as this box is long past it's EoL and support.

Regards

Sent from Cisco Technical Support iPad App

[Rafal Szeremeta]

Hello Andy

What software version of MCU do you have? Did you try upgrade/downgrade it?

There is one thing you can try:

Can you run upgrade utility then use customize option and tick 3 options only (H323 configuration, wake up option, factory default). See if that help.

Thank you

Rafal

[andypoore]

Hi

I can't run the upgrade utility because there's no IP connectivity.

On the console I get the following:

Invalid application on Flash. Running Wakeup program.

ttached TCP/IP interface to motfcc unit 0

Attaching interface lo0...done

Adding 5351 symbols for standalone.

==============================================================================

CPU              : MPC755

VxWorks Version  : 5.5

BSP version      : 1.70

Created          : Jan 11 2004, 17:43:16

WDB              : Ready.

==============================================================================

ViaIP MPC755_MPC8260.

BSP version VER_2_0_1REV 1.0

Memory Size: 128 MBytes.

HW Version:0x3

bspSetRoutingTable: Error in routeAdd.

BSP_EXC: Exception hook added

Link is Up, 100M   Full Duplex.

Duplex Mode: Manual Full Duplex.

Speed Mode: Manual 100M.

MEMORY OK (address: 0x0 - 0x3000)

Invalid application on Flash. Running the Wakeup program.

==============================================================================

So the problem remains I have no documentation on the command line, and is it possible to recover this box.

Regards