cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
550
Views
0
Helpful
2
Replies
Highlighted
Contributor

Cisco DX80 turn Proximity off after saving configuration

Hi 

I facing a strange behavior from the DX80 after upgrading it to CE8.2.2 , whenever i turn the Proximity mode on the CUCM to On , after saving it turns to off by itself . Also the Intelligent Proximity configuration tab is not found in the DX80 Admin web page , it appears just in status page .

Hope that someone have encountered such issue .

Many Thanks

Ahmed

1 ACCEPTED SOLUTION

Accepted Solutions

Proximity isn't supported on

Proximity isn't supported on the DX Series yet when running CE software, see the CE8 Release Notes on pg 19 for the list of supported/unsupported features.

View solution in original post

2 REPLIES 2

Proximity isn't supported on

Proximity isn't supported on the DX Series yet when running CE software, see the CE8 Release Notes on pg 19 for the list of supported/unsupported features.

View solution in original post

Contributor

Thanks Patrick 

Thanks Patrick 

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards