Cisco DX80 turn Proximity off after saving configuration

[Ahmed Abd El-Baky]

Hi 

I facing a strange behavior from the DX80 after upgrading it to CE8.2.2 , whenever i turn the Proximity mode on the CUCM to On , after saving it turns to off by itself . Also the Intelligent Proximity configuration tab is not found in the DX80 Admin web page , it appears just in status page .

Hope that someone have encountered such issue .

Many Thanks

Ahmed

[Patrick Sparkman · Accepted solution]

Proximity isn't supported on the DX Series yet when running CE software, see the CE8 Release Notes on pg 19 for the list of supported/unsupported features.

[Ahmed Abd El-Baky]

Thanks Patrick