Cisco SX80 removing 'No camera connected' warning from OSD

[uscourtswvnd04]

Hello.

How do I remove the 'No camera connected' warning message from the on screen display?

I am using input 4 and I don't need the camera.

Thanks again!

[TheoEconomides]

I agree - this solution worked for me in version ce9.7.8

[Steve Ogg]

Would also like to add that this is the correct answer to this problem, with no extra screen workaround required!

[PJMack]

You can't, only the original poster can choose the correct answer. This thread is three years old, the answer then was the correct answer then. 

[s.stefanidis]

That did it !

Thank you.

Log in to the codec.

(you need the IP address, username / password)

Go to:

Setup > Configuration > Peripherals > (in the “Profile” area, set “Cameras” to 0.

Press “Save” on the top right of the screen.

Message went away.