Cisco TelePresence C-series API: Shutdown command

[Rejohn Cuares]

Hi All,

I'm looking for an API command that shutdown the codec. I've checked the C-series API TC4 and TC5 for the said command but I wasn't able to find it.

Has anyone knows the command to shutdown the codec?

Thanks!

[vivsing2 · Accepted solution]

Hi,

To shutdown device i found one command on TC5.1, not checked on TC4

xcommand Boot Action:Shutdown

You can try this command to shutdown device.

Regards,

Vivek

[Martin Koch]

If you have root access you could also try the "shutdown -h now" command, but for example my E20 still just reboots

(it also does not have a powerbutton or WOL so it might be hard to turn it on again :-)

So I could picture its also dependent on the endpoint, the EX series has at least a power button.

Vivek: as the release notes of TC5.1 state that this is a new api command I would not expect it not to work in older releases.:

http://www.cisco.com/en/US/docs/telepresence/endpoint/software/tc5/release_notes/tc_software_release_notes_tc5.pdf

Changed API commands
 xCommand Boot
• Added: Action: