Cisco Telepresence endpoints and Startup Scripts

[sebastjankocelj]

Hi All,

I have telepresence endpoints connected through EDGE provisioning. With provisioning enabled, endpoints are getting address book informations from CUCM. I would like to change the address book link permanently. If I change the link, it is unchanged until next reboot, next reregistration,... If I set the startup script, it will run the script before provisioning setup. Do you have any ideas, how can I accomplish this.

BR,

S.K.                 

[amehla]

Hi Sebastjan,

MXP has separate phonebook and provisioning configurations.

for phonebook:

xconfiguration corporatedirectory mode: on

xconfiguration corporatedirectory address: IP address of CUCM

xconfiguration corporatedirectory path:https://ipaddress:8443/cucm-uds/users

for provisioning:

xconfiguration externalmanager address:

xconfiguration externalmanager path:

please make sure your external manager address is of CUCM.

[sebastjankocelj]

Hi Amit,

Long time no see..

I am refering to EX90 and SX20 endpoints.

Endpoint gets the https://ipaddress:8443/cucm-uds/users configuration. But I would like to set it to custom link. And I can. But after restart the default is configured again. I would like to find a way to make it custom all the time...

[amehla]

Hi Sebastjan,

yes long time.

is it also provisioned with CUCM ?

xConfiguration Phonebook Server 1 ID: "default"

*c xConfiguration Phonebook Server 1 Type: CUCM

*c xConfiguration Phonebook Server 1 URL: "https://:8443/cucm-uds/users"

*c xConfiguration Provisioning Mode: CUCM

*

*c xConfiguration Provisioning ExternalManager Address:

*c xConfiguration Provisioning ExternalManager Protocol: HTTP

*c xConfiguration Provisioning ExternalManager Path: ""

*c xConfiguration Provisioning ExternalManager Domain: ""

*c xConfiguration Provisioning Connectivity: Auto

if this is changing after restart or reboot, this is something related to provisining

try to disable provisioning by xConfiguration Provisioning Mode: off and check if it still changes or not.

[sebastjankocelj]

If provisioning is Off, then the registration fails. So after setting mode to Off, the endpoint unregisters. And then I set it to Edge again, and it is registered, with all settings changed from CUCM. So I need to run Startup Script again, to set all needed settings to required.

Any more clues?

[amehla]

yes, provisioning may cause your device to unregister if it is set to off.

however, provisioning and phonebook settings are separate on SX20 and EX90, so even though it is unprovisioned , you should get phonebook.

if after doing a restart, phonebook stay, then we can see why keeping provisioning to on losses phonebook.

just a small test to check