I have a CUCM setup with Cisco Unified Meeting Place with software bridge for voice and video. I want to bring in Video endpoints registered to VCS but want to use the meeting place as the conference bridge(Multipoint switch)
Please advise if this is possible and also advise on the best design for the VCS and Call Manger environment.
I dont think this is possible with software bridge, you will need atleast MCU for video conferencing. if you want invoke conference from CUCM endpoints then register MCU with CUCM as conference bridge . If you want to invoke from VCS then you need MCU register to VCS.
Cisco Unified Meeting Place is already acting as a video Bridge for the SX20 units registered on the Call Manager. To allow for SIP compatility calls from the Internet, introducing the VCS expressway will be the solution.
If these calls are forwarded to the Meeting Place, shoukd it not be possible to join an already active video conference on meeting Place?
This document is intended to receive any new ideas for TAC to create new useful walkthrough videos to help set up deployments, integrations, etc.
Feel free to share any feedback about new walkthrough videos you consider useful, please share your o...
Configuring Cloud Connected PSTN (CCP) – Easy as 1-2-3!
STEP 1: PREPARE
Before you can configure your CCP in Control Hub, you must procure PSTN services from an authorized Webex Calling CCP Partn...
To participate in this event, please use the button to ask your questions
This topic is a chance to discuss more about how to read Cisco Unified Communications trace files. In this session, Cisco D...