I have a CUCM setup with Cisco Unified Meeting Place with software bridge for voice and video. I want to bring in Video endpoints registered to VCS but want to use the meeting place as the conference bridge(Multipoint switch)
Please advise if this is possible and also advise on the best design for the VCS and Call Manger environment.
I dont think this is possible with software bridge, you will need atleast MCU for video conferencing. if you want invoke conference from CUCM endpoints then register MCU with CUCM as conference bridge . If you want to invoke from VCS then you need MCU register to VCS.
Cisco Unified Meeting Place is already acting as a video Bridge for the SX20 units registered on the Call Manager. To allow for SIP compatility calls from the Internet, introducing the VCS expressway will be the solution.
If these calls are forwarded to the Meeting Place, shoukd it not be possible to join an already active video conference on meeting Place?
Is there a way in UCCE with using an admin script maybe using the email application in Call Studio to send out an email? I know in UCCX you can send out an email if the script were to fail but is there a way to do it in UCCE? Any help would be great!
Fun lab with Packet Tracer and running Cisco CME with 3 ip phones, 3 laptops, 1 switch, and 1 router. Fun lab with repetition. You will be able to test your phones and laptop for connectivity etc. Solution;see attached CME Packet Tracer L...
How to configure IP Address for Cisco Integrated Management Controller CIMC. The Cisco Unified Computing System (UCS) is a data center product composed of computing hardware, virtualization support, switching fabric, and management software.