Onequestion...I have oneCUCMclusterversion 11andIM andPresence server 10.5 ,inCUCM its registeredDX80 endpoints,it'spossibleWith theIM &Presenceservercreate multi conferencesforthreeParticipants or more??
you need to install a Telepresence Server Bridge to have a conference for more than 2 participants. You can either install Telepresence Server on a virtual appliance or you can buy hardware appliance from Cisco.
I have been tasked with some more people to add DX80's to the CUCM in our future. I was hoping that you can point me into the right direction, where I can download the instructions to complete the job.
QuestionGood morning. I am looking for the equivalent of the System Manager Guide Supplement for the SS7INNIC as found on the UCCE CallRouter. Specifically, There should be a table for the EMSUserData Mapping so I can drill down on specific informati...
Hello guys,As I have read the Facebook messenger could integrate with UCCX to handle chat as webchat support,. there is a webhook on Facebook that instructed us to write the CCP URL with HTTPS as a Callback URL after writing the tokens from UCCX to FB and...
You can use the CLI command 'show risdb query sip' to check the status of SIP Trunks on Cisco Unified Communications Manager (Unified CM, CUCM).
admin:show risdb query sip
----------- SIP Information -----------
Number of SIP entries: 1