Configuration for SIP Trunking between Avaya IP Office and Cisco CallManager Express 7.1

[femi.agboade]

Hi,

I have the task of allowing calls route between an Avaya IP Office and a CCME running on a 3825 router. I have both devices on the same subnet, but I have been unsuccessful so far in getting calling routed between them.

I would appreciate any pointers in getting this done as I would rather start from scratch.

All comments and suggestions are very welcomed.

Regards,

Femi

[Marwan ALshawi]

Can you post the cme config

Sent from Cisco Technical Support iPhone App

[femi.agboade]

Hi there,

I posted this same question in another forum and I have it resolved already. Kindly refer to the link below:

https://supportforums.cisco.com/message/3501347#3501347

Regards,

Femi