Convert 7985 from SCCP to H323 or SIP?

[Michael Boscia]

Where can I find the documentation the describes how to convert a 7985 (T150) from a SCCP load to either an H.323 or (if available?) a SIP load so I can register it to my VCS-C/E instead of just CUCM.

[Jens Didriksen]

You would've been able to do that with just about any other TANDBERG system, but the 7985 (T150) doesn't fall into that category - unless things have changed now that TANDBERG is Cisco see:

http://vtctalk.com/forum/showpost.php?p=72254&postcount=9

/jens

[Michael Boscia]

How do I tell the difference?

This unit is Tandberg branded/badged, not Cisco.

Am I in luck?

Sent from Cisco Technical Support iPad App

[Jens Didriksen]

Don't know - guess best bet would be to either contact your Cisco rep or open a case with TAC and see if you can get a key for it.

/jens

[Martin Koch]

Not sure if it works for the 150mxp, but maybe this document helps you:

How to convert a MXP 1000 with SCCP M2.x Firmware to a MXP 1000 with F9.X Firmware:

https://supportforums.cisco.com/docs/DOC-24414.pdf

Anyhow it would require a valid license key like Jens mentioned.

It might be better then nothing in a lab enviroment, but to be honest, do you really want to use it?

JabberVideo will give you a better quality.

Getting some E20 as long as they are available might be a good idea as well :-)