cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
457
Views
5
Helpful
1
Replies

CTS1300 Hardware Setup

James Hawkins
Level 8
Level 8

Hi,

Is it possible to complete the hardware setup (cameras, microphones etc.) of a CTS1300 system without having it registered to a CUCM cluster?

I am scheduled to install one for a customer but their network provisioning date has slipped.

Would it still be possible for me to complete the setup or should I delay the work until the network is available?

Thanks

1 Reply 1

marrachart
Level 1
Level 1

That's no problem. You can even do the camera setup.

What I've done earlier is install a CUCM on a small server or vmware with the correct ip address AND firmware., take a switch an you can register the cts, you can upgrade to the correct firmware and have it all done.

After that, you just wait untill the network is ready and et the customer turn the system on.

Should work...

Sent from Cisco Technical Support iPad App

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: