Being so happy that i finally managed to make my C2600 with FXO-M2 ports understand the disconnect tone of China Telecoms/China Mobile I would like to help others also.
Unfortunately cptone cn never worked for me correctly, letting the hook off whenever a placed had been terminated from the pstn side of the loop. Meaning whenever a pstn callee was dialing my china telecom numbers and my internal Asterisk was replying (with IVR or whatever) the line would remain open forever unless
1. the line had been answered and terminated from any internal user
2. the whole voice interface would be reset by me
Trying with a custom-cptone seems that everything works fine now.
Here are my settings
supervisory disconnect dualtone mid-call
supervisory custom-cptone LAND
timeouts wait-release 1
!In China there is no actualdual tone. Disconnect tone is transmitted every 350ms on 450Hz for landlines (China Telecom) and every 500ms on 425Hz on GSM (China Mobile)
NIM-PVDM is the Next-generation digital signal processor (DSP) module with an onboard DSP daughter card which eliminates the need to procure an additional T1/E1 NIM card in order to utilize a PVDM4 chip for IP media services. This module enables the new C...
QuestionGood morning. I am looking for the equivalent of the System Manager Guide Supplement for the SS7INNIC as found on the UCCE CallRouter. Specifically, There should be a table for the EMSUserData Mapping so I can drill down on specific informati...
Hello guys,As I have read the Facebook messenger could integrate with UCCX to handle chat as webchat support,. there is a webhook on Facebook that instructed us to write the CCP URL with HTTPS as a Callback URL after writing the tokens from UCCX to FB and...