I'm trying to exchange calls between 2 SIP proxies and and a cisco gateway (AS5300) Let me first show you what what I'm trying to accomplish before I explain my problem
SIP_Proxy_1<--->AS5300<-->SIP_Proxy_2 | | PSTN
Calls are sent from proxy 1 to proxy 2 with prefix 2222 Calls are sent from proxy 2 to proxy 1 with prefix 1111 Proxy 1 and proxy 2 calls out to PSTN through the gateway with prefix 9999 proxy 1 and proxy 2 do NOT dial fixed length digits after the prefix, it always varies.
here are my dial peers settings:
dial-peer voice 1111 voip destination-pattern 1111T voice-class codec 10 session protocol sipv2 session target ipv4:192.168.1.1 dtmf-relay rtp-nte no vad ! dial-peer voice 2222 voip destination-pattern 2222T voice-class codec 10 session protocol sipv2 session target ipv4:192.168.1.2 dtmf-relay rtp-nte no vad !
dial-peer voice 100 pots destination-pattern 9999T no digit-strip direct-inward-dial port 0:D !
I'm sure I have Dial-peers not configured right but I cannot figure it out. when SIP proxy 1 calls exten 2222175 at proxy 2 going through the AS5300, the AS5300 returns (SIP/2.0 404 Not Found). Any guidance on how I can accomplish this task is really appreciated, I'm no cisco guy but I'm under so much pressure Dave,
When you call through the Access server like this it will be an IPIP call. Make sure you have:
voice service voip
allow-connection sip to sip
configure. And also I would not use voice class codec. It is not supported with IPIP gateway below the version 15.1(2)T. It might lead to codec mismatch. If after adding the commands which I have suggested the calls still does not work please collect:
debug ccsip messages
debug voice ccapi inout
from the AS5300 along with the dialpeer configuration.
Table of Contents:
1. Reference URLs
2. Type of Certificates
3. Regenerate certificates that have no CTL/ITL impact [no phone impact]
4. Regenerate certificates that have CTL/ITL impact [medium phone impact]
5. Step to delete expired certif...
I have been using the recent release of the WebEx Desktop App (39.9) which has Wireless Sharing feature. Prior to this, we were using the proximity application for sharing, where we can find the performance logs on the %temp% folder of the client machine....
Cisco Recommends Dual NIC deployment for Expressways. But single NIC deployment can be achieved. Points to be noted for single NIC: > Firewall must support NAT Reflection, if not then you can use dual NATing to achieve NAT reflection on unsup...
Learn how Cisco is transforming how you communicate in the modern workplace with new capabilities like expanded Webex calling, unified app experiences, and intelligent devices and tools.
Webex Unified Platform
Deep Dive Briefings