Hi,
i configure FAX-Server with CUCM 7.X
i stuck some where i have a problem when some one calling out side. it's connected but after 4 second it's hang out.
Internal it's working fine.
I configure two NON-GK trunk one for FAX-SERVER and one for Voice-GW.
Here i m sharing the configuration.
1. Configure Dial-Peers - POTS
dial-peer voice 1010 pots
destination-pattern 1010....
no digit-strip
direct-inward-dial
port 0/0/0:15
exit
2. Configure Dial Peers - VoIP
dial-peer voice 10120 voip
description H323 to CUCM
destination-pattern 10120...
voice-class h323 1
session target ipv4:192.168.1.11
session transport udp
codec g711ulaw
exit
Set the following:
• Device Name: SR140-H323
• Device Description: SR140-H323
• Device Pool: Default
• Call Classification: OffNet
• Server 1 IP Address/Host Name: 198.168.1.90
Note: Server 1 IP Address/Host Name is the IP address of the SR140.
Select Inter-Cluster Trunk for the Device Protocol and press Next.
Set the following:
• Device Name: GatewayTrunk-H323
• Device Description: GatewayTrunk-H323
• Device Pool: Default
• Call Classification: OffNet
• Server 1 IP Address/Host Name: 192.168.13.50
Note: Server 1 IP Address/Host Name is the IP address of the Gateway.
Press Add New
Set the following:
• Route Pattern: 101021XXX
• Description: 101021XXX
• Gateway/Route List: GatewayTrunk-H323
• Call Classification: OffNet
Repeat the same steps and set the following to route to the SR140:
• Route Pattern: 101101XXX
• Description: 101101XXX
• Gateway/Route List: SR140-H323
• Call Classification: OffNet
Please help me out.
Regard's
Arun
+91-8088071229
CCIE# 47139