cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
967
Views
0
Helpful
3
Replies
Highlighted
Beginner

Do E1 need always CCS or CAS ?

Hi, Please help me.
I have to implement VoIP using MPLS like following.

PBX-A---(E1)---Cisco2811---MPLS---Cisco3725---(E&M)---PBX-B

I need to configure Cisco2811 and need to ask PBX-A vendor to add E1 card  and configuration to PBX-A.
Should I pay attention to CCS ( or CAS ) between PBX-A and Cisco2811 ?
Does It has nothing to do with this case ?

(FYI)

controller E1 1/0
framing crc4
clock source line       
linecode hdb3
ds0-group 1 timeslots 1-8 type e&m-wink-start

3 REPLIES 3
Highlighted
Hall of Fame Master

Re: Do E1 need always CCS or CAS ?

Ask for ISDN PRI (CCS).

Highlighted
Beginner

Re: Do E1 need always CCS or CAS ?

Thank you for your commnet. I really appreciate your answer.

Does it mean DS0 signaling require CCS ?

According to folloing URL, NM is available for both CCS and CAS.

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a008039c333.shtml

Could you give me the refelence URL in detail which provide information regarding  CCS required under this case?

I am really confused.

Highlighted
Hall of Fame Master

Re: Do E1 need always CCS or CAS ?

2811 does not require NM, use VWIC and PVDM2 directly.

It would be better if you engage a voice network engineer for the project, because if you have no experience it will take much time and errors for you to get it right.

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey