cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
698
Views
0
Helpful
3
Replies
Highlighted
Beginner

Does C20 SX20 C40 codec can be registered to CUCM externally

I have Cisco video telepresence system with endpoint registered to CUCM. With MRA, you can have IP phone deskphone and DX series endpoint registered to CUCM using MRA externally. I have C20, SX20, C40 and C60 codec and MXP95 thirdparty endpoint regsitered to CUCM. Can I registered this endpoints in CUCM from external network. With newer endpoints you can have cloud capability. If yes, how can I registered to CUCM from external network?

Everyone's tags (2)
3 REPLIES 3

You can register TC and CE

You can register TC and CE based endpoints to CUCM through MRA, however the MXP and thrid-party systems aren't supported.  Take a look at the Collaboration Edge TC-based Endpoints Configuration Example, for CE based endpoints the process is the same.  For the most up to date list of endpoints that support MRA, refer to the Expressway Data Sheet

Beginner

Thank you. I have another

Thank you. I have another question regarding registering TC/CE based endpoint to internet. e.g. If I get IP address and access to internet when I take this endpoint to external network. I know SX10/20 had that capability where you can get IP address and access to internet and you can dial any SIP URI to make call. You do not need any call control to register codec. Is that something available with TC/CE endpoints.

You can configure the

You can configure the endpoint to be standalone, which isn't registered to any call control server such as CUCM.  For the required configuration that has to be done on the endpoint and firewall. take a look at Vivek's post here: sx20-standalone.

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards