08-10-2016 07:59 PM - edited 03-18-2019 06:15 AM
If I upgrade the DX80s to CE8.2, when I have a multiparty call using conductor as an adhoc bridge, can I get to choose layouts like the SX series?
08-10-2016 08:44 PM
I know you can change the layout if you're sharing or receiving content, but not sure when content isn't being presented as it's not mentioned in the DX CE8 User Guide. You can see in the screenshots of the guide, there is no layout option in the upper right on any of the "Video Calls" pages compared to the "Sharing Content" pages.
08-11-2016 08:30 AM
Patrick,
I hit the correct answer by MISTAKE.
I see the answer in the guide. I obviously saw that in the guide. But the question is about multi call not content sharing.
Hoping to find out about multi party call.
08-11-2016 09:53 AM
The DX supports ActiveControl, so I would think that you could change layouts if you're connected to a Conductor controlled TelePresence Server. I have a few DX80's in my office, I'll set one up tomorrow and take a look.
08-23-2016 08:54 AM
When connected to a Conductor managed TelePresence Server, you can use ActiveControl to change the layout presented to the DX70/80 when running CE software. However, with ActiveControl disabled or using anything else other than a TelePresence Server with ActiveControl, there doesn't appear to by any layout options available.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: