cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
444
Views
0
Helpful
2
Replies

Endpoint registration to VCS-Control cluster

GM2020
Level 1
Level 1

 

Hi,

We have VCS cluster in our environment (Primary and secondary VCS-Control and VCS-Express). I could see almost equal number of endpoints registered on each VCS-Control. How does the Endpoint know to which VCS-Control server it has to register to ? How does this load balancing is acheived . any setting that i have to look for ?

Thanks!

1 Accepted Solution

Accepted Solutions

Patrick Sparkman
VIP Alumni
VIP Alumni

This would depend on how you have your DNS setup.  Can you tell us in detail how you have your endpoints registering to the clusters, as well as how you have your DNS configured?  Are you using SRV records, round-robin?

The VCS Cluster Deployment Guide, appendix 5 goes over how to setup your endpoints to register to the cluster and the different methods of doing so.  Appendix 6 covers SRV records.

View solution in original post

2 Replies 2

Patrick Sparkman
VIP Alumni
VIP Alumni

This would depend on how you have your DNS setup.  Can you tell us in detail how you have your endpoints registering to the clusters, as well as how you have your DNS configured?  Are you using SRV records, round-robin?

The VCS Cluster Deployment Guide, appendix 5 goes over how to setup your endpoints to register to the cluster and the different methods of doing so.  Appendix 6 covers SRV records.

 

Thanks for the correct answer and pointing to the correct doc. It was very useful.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: