cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
442
Views
0
Helpful
1
Replies

EX 90 T.C 6.2 failed encryption registering to CUCM 10.5

macieknowak
Level 1
Level 1

Hello,

I am trying to register EX90 TC6.1.0.c4723e9 in encryption mode to CUCM 10.5.
The registration status is unregister (when I use non-secure profile registration is OK).
I have set the CUCM to secure mixed-mode.
My security profile for Ex 90 setting :

EX 90 status :

1 Accepted Solution

Accepted Solutions

Manish Gogna
Cisco Employee
Cisco Employee

Hi,

It looks like you need to install a LSC on the endpoint, you can follow the instructions as per page 15 of the following link

http://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/codec-c-series/tc7/administration-guide/administering-endpoints-running-tc70-on-ucm912.pdf

 

Manish

- Do rate helpful posts -

View solution in original post

1 Reply 1

Manish Gogna
Cisco Employee
Cisco Employee

Hi,

It looks like you need to install a LSC on the endpoint, you can follow the instructions as per page 15 of the following link

http://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/codec-c-series/tc7/administration-guide/administering-endpoints-running-tc70-on-ucm912.pdf

 

Manish

- Do rate helpful posts -

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: