10-07-2016 08:25 PM - edited 03-18-2019 06:27 AM
Hi Cisco Team.
Pls, help to check issue, when register Cisco DX80 in CUCM
Status: Failed: 485 Ambiguous / Device type mismatch
Thanks team.
10-10-2016 11:16 AM
Hi,
What device type are you using in CUCM?
With CE software on the DX series, it requires a device type of "Cisco Telepresence DX80"
and not the "Cisco DX80" device Type.
-Jonathan
10-10-2016 08:31 PM
I using Cisco Telepresence DX80. it registered in CUCM. Thanks you for support.
10-10-2016 12:14 PM
If you haven't already, you should install the proper device pack on your CUCM to add the new "Cisco TelePresence DX" device types that are used when running CE software on the DX70/80, these device types are different than the "Cisco DX" device types that run Android software. If you haven't done so already, suggest you take a look at Convert between CE software and Android-based software.
10-10-2016 08:30 PM
Thanks so much, Cisco TelePresence DX80 registered on CUCM.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: