cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
339
Views
5
Helpful
1
Replies

H323 endpoints registered on VCS talking to MX800 registered on CUCM

marcusdewaal
Level 1
Level 1

Hi

 

I have an MX800 registered on CUCM 10.5. I have also enabled SIP between the CUCM and VCS server. However I have 3rd party VC endpoints that can only register to the VCS as H323 devices. My question is, is it possible to set up a VC session between the MX800 (registred on the CUCM) and the H323 3rd party device (registered on the VCS) or would I need a MCU to transcode\interoperate between h323\SIP? Would the MCU work in tis case?

 

Regards,

Marcus

1 Reply 1

Hello,

Your VCS works as H323-SIP gateway. No need additional devices for interoperate between mx800 and 3rd party device.

http://www.cisco.com/c/dam/en/us/td/docs/telepresence/infrastructure/vcs/config_guide/X8-5/Cisco-VCS-SIP-Trunk-to-Unified-CM-Deployment-Guide-CUCM-8-9-10-and-X8-5.pdf

br Oleksandr

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: