07-23-2019 05:14 AM - edited 07-23-2019 05:14 AM
Question's pretty much in the title, I can't seem to find any way to do this through the API or the web interface. Hopefully I'm just being blind.
We could just put an anti tamper label over USB ports, but it'd be nice to completely disable it for added security.
Solved! Go to Solution.
07-23-2019 08:30 PM
Hello,
Android based DX80 software is already announced EOL please see the below link-
If you don't have any particular requirement to use android then you can convert it into CE version. Below is the link
If you don't have UCM then see section" Migrate a DX device to CE software with no Cisco UCM"
Thanks
Please rate if it is helpful.
07-23-2019 08:30 PM
Hello,
Android based DX80 software is already announced EOL please see the below link-
If you don't have any particular requirement to use android then you can convert it into CE version. Below is the link
If you don't have UCM then see section" Migrate a DX device to CE software with no Cisco UCM"
Thanks
Please rate if it is helpful.
07-29-2019 07:11 AM
Ah! Clearly I didn't read enough, I was wondering why I couldn't find anything about it in the documentation. We're already on CE, thanks for your help!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: