Solved: Re: How to enable HTTPS login access to VCS 8.x

marco_81 · ‎12-05-2017

Hi all,

i was trying some settings on Cisco VCS and absently i disabled HTTPS access to login page. So now i cannot access to web gui. Is it possible to enable HTTPS again from CLI?

thanks

Wayne DeNardi · ‎12-05-2017

The CLI command you are looking for is:

xConfiguration Administration https Mode: On

Wayne

Please remember to mark helpful responses and to set your question as answered if appropriate.

View solution in original post

Joe Vallender · ‎12-05-2017

Are you able to SSH into the VCS? There may be an xconfiguration command to turn on https access.

Wayne DeNardi · ‎12-05-2017

The CLI command you are looking for is:

xConfiguration Administration https Mode: On

Wayne

Please remember to mark helpful responses and to set your question as answered if appropriate.

marco_81 · ‎12-06-2017

yes i'm able to login as admin via SSH, then perform the command you suggest and then a restart and all is it. All CLI commands are available on VCS Administration Guide. Remember to login ad admin and not as root.

thanks.