10-28-2019 11:26 PM
Web browsing issue with my WEBEX Room 55's. I was pushing a template via TMS to three of my systems that have ce9.8.0.
One of my template settings is "http mode:" and I accidentally set it to off vice https. So I pushed the template.
Than was unable to browse to the systems. So I used SSH and using xcommand networkservices http mode: https and appreared to turn it back on ?
Now when I browse to the system I get the following:
BAD GATEWAY
The request could not be served due to a proxy error
Return to the front page
When I click on the link "Return to the front page" nothing happens ???
10-29-2019 12:44 AM
Hello,
It happened to me as well my endpoint was registered with CUCM so i disabled and enabled the web access from CUCM age and rebooted the endpoint it works.
Try rebooting the unit if it does not fix try a factory reset and reconfigure it again and see if it works.
Thanks
Please rate if it is helpful...
10-29-2019 01:04 PM
As you are managing these endpoints through TMS so I would think VCS is a call control in your case.
It happened to me quite often, try another web browser or clear the cache/history from the browser.
Also try the RemoteAccess Allow field if your endpoints are remotely managed endpoints.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide