In this file(admin.prf) i can modify the IP adresses, so i can acces the Content Manager as an admin. BUT, how can i give more IP adresses?I read about this(with AND), but it dosen't work.
make sure to comment out the default 255.255.255.255 0.0.0.0 with a "#' at the beginning of the line and make sure the # is gone for your new ip address lines. Make sure to save the file before attempting to test the changes.
We have exactly the same problem with our content server, we can't get the "AND "to work. Have you a work around for this issue yet ? if you have please let me know.
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
view more
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
view more
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...
view more
