cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

167
Views
0
Helpful
1
Replies
Beginner

IPVC password :)

Hi,

What is the password for the IPVC3540?I need the default password for the OS, not only for the VNC.

By the earlier modell it was "admin" , but it dosen't work now.

Thx,

Akos

1 REPLY 1
Cisco Employee

Re: IPVC password :)

By default the password on most 3540 systems is null or blank. This applies to MCU's and Gateway web log in. As you reference the OS and VNC password I am guessing you are looking to access the AS module. If this is the case, here is some information I posted on another message.

====

Depending on the version of software you are running the defalut VNC password could be a couple of the following...

The default VNC password for certain 2.X or below should be "123" as displayed here...

http://www.cisco.com/univercd/cc/td/doc/product/ipvc/ipvc3540/as_mod/rel_1_0/appc.htm

For 2.2.x, 3.X and above it could be "admin"

http://www.cisco.com/univercd/cc/td/doc/product/ipvc/ipvc3540/as_mod/rel_1_0/rel_3/asrnv30.htm

The windows login should be user:cisco or Cisco password:admin by default. If it has been changed and you cannot get into the system, the IPVC TAC should be able to get get into the system with a support use only admin account.

---

Link to similar message post...

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=IP%20Communications%20and%20Video&topic=Video%20over%20IP&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dd77ec6

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards