cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1939
Views
0
Helpful
5
Replies

is there any way to disable gatekeeper registration requests

antonis.p
Level 1
Level 1

I need to stop the automatic gatekeeper registration request (towards 224.0.1.41).

Is there any command that performs this?

1 Accepted Solution

Accepted Solutions

Martin Moran
Level 3
Level 3

Hi @antonis.p,

You can configure your gateway to send unicast GRQs to the Gatekeeper you want with the following h323 interface command:

GW(config-if)# h323-gateway voip id <GK ID> ipaddr <GK IP> <port, 1719 by default> priority <priority value>

This prevents that your gateway sends requests to the multicast address (224.0.1.41) instead it only sends the GRQs to the GK that you assing in the previous command.

HTH.

Rgrds,

Martin, IT Specialist

View solution in original post

5 Replies 5

William Bell
VIP Alumni
VIP Alumni

I am not sure which device you are trying to configure but if you are talking about IOS then my guess is that you have the "gateway" configuration applied at the global level. When enabled, the IOS device will start sending out GRQs to the 224.0.1.41 mcast group. Use the "no gateway" command to disable.

 

HTH

-Bill (@ucguerrilla)

http://ucguerrilla.com

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Thank you William, 

However the "no gateway" command will stop ios gateway to work as gateway. I am thinking placing an access list to stop GRQ packets, but is there any  smarter solution?

Regards,

 

Antonis

Yes, ACL is the best way to go

Martin Moran
Level 3
Level 3

Hi @antonis.p,

You can configure your gateway to send unicast GRQs to the Gatekeeper you want with the following h323 interface command:

GW(config-if)# h323-gateway voip id <GK ID> ipaddr <GK IP> <port, 1719 by default> priority <priority value>

This prevents that your gateway sends requests to the multicast address (224.0.1.41) instead it only sends the GRQs to the GK that you assing in the previous command.

HTH.

Rgrds,

Martin, IT Specialist

Hi

i have h323 gateway gives the below error 

%CCH323-2-GTWY_REGSTR_FAILED: Gateway h323Gateway failed to register with Gatekeeper X.X.X.X even after 2 retries 

where X.X.X.X is the IP address of our expressway-C because we a mobile remote access solution ( MRA )

any advise to stop this

thanks....

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: