cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
887
Views
0
Helpful
1
Replies
Omar Abdelhalim
Beginner

ISDN Link

Dear All,

Can I use the Cisco Tandberg ISDN Link with C40 V.C unit using EtherNet Switch in between as in the Attached Draw?

Thanks

Omar Mahmoud

1 REPLY 1
Marius Nedregaard
Cisco Employee

Hi Omar.

This is not a supported setup.

I would recommend you to extend the ISDN and place the ISDN link close to the codec.

//Marius

EDIT: It could work, but not supported - and if you were to contact TAC to get support troubleshooting it you would have been denied.

Message was edited by: Marius Nedregaard

Content for Community-Ad

Spotlight Awards 2021